Machine26914391280

What to do after buying a miter saw?

You now own one of the most innovative power tools out there… the compound miter saw. This amazing tool can easily and accurately cut two inclined surfaces at the same time (a compound angle). This means that a miter can be cut across the entire surface of the board and at the same time a bevel can be cut at the end. At first, it may seem a bit complicated. But relax! Here are some tips to help you get started on the right foot.

Install The Saw In A Suitable Place

After removing the saw from its box, the first thing to decide is where to put the tool in the shop or on the job site. It is best to fix it on a workbench or place it against the middle of a long wall. This allows cuts on both sides of the sheet. If there is no longer wall, try placing the saw near a door or other opening that can provide room for longer boards. You will need the best table saw under 1000 for doing that.

Take Safety Precautions

Take a moment to read the instructions and safety guidelines that come with your miter saw. Wear eye and ear protection when using your saw. Do not wear loose clothing, jewelry, or dangling objects when using a miter saw. And remember, always keep your hands away from the blade at least 15 cm (15 cm).

Practice With Straight Cross Sections

For a straight cross cut, set the bevel and miter scales to 0 °. Place the workpiece firmly against the fence and clamp it firmly in place. Miter saws come with vertical clamps that apply downward force to the workpiece. This prevents the cylinder head from lifting toward the blade, causing damage and possible injury. In addition, long stands must be supported flush with the surface of the turntable.

When you’ve finished cutting, turn on the saw and wait for the blade to start. Then move the saw head downward in a controlled cutting motion. This is why it is often called a “puzzle.” When locked in position, the slide miter saw can cut in the same way.

If you are lucky enough to have a slide miter saw, you will be able to cut a larger material. When the head is unlocked, it can slide from its home position towards the front of the machine. When cutting with the slide mechanism, the blade is pushed back through the material. Thrust is an important safety factor! The force of the cutting action and the wire saw blade are directed away from you.

When finished cutting, do not lift the saw with the blade rotating. Instead, release the power switch and allow the blade to come to a complete stop before raising your head. Otherwise, the rotating blade can rip or catch a cut piece and throw it into the air.

Try Some Miter And Bevel Cuts

The miter and bevel settings can be used separately. In other words, you can cut a miter or bevel with the sliding compound miter saw. More importantly, they can be used together to cut both at the same time.

The angle of the flange to be cut is adjusted by positioning the turntable according to the scale. The miter scale is located on the front of the base. To adjust the miter angle, loosen the table lock mechanism and turn the turntable to the desired angle. Then release the lock lever and tighten the lock knob to hold the table and saw head in position. You may notice that there are several preset positions on the base. These are commonly used angles.

The bevel angle can be set to any angle from 0 to 45 degrees. As with the miter setting, a graduated scale, angle indicator, and locking mechanism are provided for this function.

Again, make sure the workpiece is held firmly in position. When making these cuts, use the same motions as for straight cross cuts.

Your cutting precision will increase with experience. But, until you can make perfect cuts, sneak up on your cutting line. First, make a first 1⁄16 ”cut on the waste side of your cut line. Then cut to the line. This finish cut will be clean and sharp.